1 2

CZone 80-911-0156-00 Contact 6 Non-Fused with Seals and Plug

CZone 80-911-0156-00 Contact 6 Non-Fused with Seals and Plug

CZN80-911-0156-00

$305.90 USD
$305.90 USD
Sale Sold out

Czone Contact 6 is a digital control and monitoring module that can be networked with other CZone products or a stand-alone. Offering six independent channels that are positively or negatively switched and is ideal for smaller marine applications or recreational and specialty vehicles, it is non-fused & comes with seals & plug.

Features:

  • Entry level digital switching module for Marine and RV applications
  • Stand alone or networked with other CZone products
  • Compatible with CZone integrated Multi-Function Displays (MFDs)
  • Six independent relay channels with positive and negative switching
  • Uses proven CZone technology
  • Internal auto-resetting PTC fuses (112818,112819 Only)
  • Electronic relay bypass switch
  • Status LEDs/fault codes for all channels
  • Low current draw – 35mA
  • Cost effective Amp connectors
  • IPX5 ingress protection
  • NMEA2000 compliant

Specifications

CZONE 6

Output Channels
6 x Relay
Output Ratings
7.5A max per channel
LED Status indication
Yes
Parallel
Yes
Dimming
No
Current Sensing
No
Circuit Protection
Internal PTC Fuses (auto-reset)
Overcurrent Alarm
No
Circuit Bypass
Yes (electronic)
Connector
Amp 18 Way Connector
Max Wire Size
16AWG (1mm²)
Maximum Current
30A Continuous
Power Consumption
35mA (standby)
Voltage
9-16V
Ingress Protection
IPx5
Communication
NMEA 2000
Operating Temp
-15 °C to +55 °C (5 °F to 131 °F)
Certification
CE, NMEA

Installation Details

1. Mounting Requirements
Location: Choose an accessible spot where indicator LEDs are visible.
Orientation: Can be mounted either vertically or horizontally.
Clearance: Maintain at least 10mm clearance around the sides and top, and ensure there is enough space above the unit to remove the cover.
Fastening: Use four 4mm (8G or 10G) screws or bolts to secure the interface to a sturdy surface.

2. Wiring & Connections
Output Connector: Feed wires through the cable grommet. Strip and insert each wire into the connector (accepts 24AWG – 8AWG or 0.5–6mm cables).
Tightening: Secure the connector screws to 4.43 in/lbs (0.5 Nm).
Relay Configuration: The dry contacts allow for positive, negative, or reversing motor control (e.g., shades or lifts).
Network: Connect a CZone Smart Harness or an NMEA 2000 drop cable to the network port. Ensure the network is properly terminated.

3. Configuration & Startup
Dipswitch Settings: Set the physical dipswitch to match your system’s configuration file using a small screwdriver.
Automatic Setup: In most cases, a new module will automatically read the configuration from the network once plugged in if a matching dipswitch value is set.
Testing: Power up the NMEA 2000 network; the outputs may flash briefly during boot. Check the Network Status LED and use the CZone Configuration Tool to verify software versions and circuit functionality.

Pelagic Power Tip

Since this specific model (80-911-0156-00) is non-fused, it does not provide overcurrent protection for your devices
Tip: You must install an appropriately rated external fuse for each of the 6 channels to protect your wiring and connected loads.
Limit: Ensure the total continuous current for all combined loads does not exceed 30A for the entire module.

Out of stock

View full details

Have a Question?